A bridge is not a mandrel — and the difference saves you from oversized sleeves
The mandrel stays in the press. The bridge is how you step up in diameter without a very thick plate sleeve.
These two words get used interchangeably in some pressrooms, and that’s how plants end up buying the wrong tooling.
A mandrel is the shaft in the deck. In most flexo presses it’s an air mandrel, and it lives in the press. You rarely remove it, and you shouldn’t have to replace it often. Plate sleeves, or bridges, mount onto that shaft.
A bridge is an adapter: a relatively thick-walled sleeve that mounts on the mandrel and presents a larger outside diameter, so a thinner plate sleeve can ride on top. That’s how you run a larger repeat — or a range of repeats — without an oversized, heavy plate sleeve for every jump in circumference. One mandrel standard, a set of bridges, and a library of thin plate sleeves is a common, economical way to cover the work on a deck.
When you quote this tooling, say which one you need. Give the inside and outside diameters, the face length, the BCD or repeat, and the notches the press already uses. Specify a bridge without the sleeve that will ride it, or treat a mandrel like a disposable sleeve, and the stack can end up out of tolerance.
If you’re building or cleaning up a sleeve library, start with the mandrel standard you already have, then decide which bridges cover the repeats you actually run.