Why the chamber is leaking — and why tightening the blade will not fix it

End seals exist so the blade can do its job. A leak is a seal problem until proven otherwise.

A leaking enclosed chamber is messy, expensive, and hard on the anilox. Ink weeps at the ends, the deck gets slippery, and someone reaches for the blade adjuster. Tightening the blade will sometimes slow the leak for a few minutes, but it also raises the pressure on the ceramic and still leaves you with a seal that does not fit.

End seals close the chamber so ink stays inside and the blade can wipe. They swell, take a set, shred, or get installed in a size that was close enough for a different chamber. Solvent, water, and UV inks do not treat the same foam or felt the same way, and a seal that lived a long life in water-based ink can fail early in an aggressive solvent or UV system.

The fastest path to a match is usually a used seal, a part number, and the press and deck. If you’re also changing blade thickness, say so — the seal often has to change with it.

Replace seals with the blades, on a planned interval, and store spares uncompressed. A seal that spent a month under a toolbox will not come back to size in the chamber.

Related product page All resources Request a quote